Technicalproduct documentation- Springs
Part1.Simplifiedrepresentation
Committeesresponsibleforthis British Standard
The preparation of this British Standard was entnusted to Technical CommitteeTDE/4 Engineering drawing practice upon which the following bodies were represented
British Gas plc Atomic Weapons EstablishmentBritish Standards SocietyElectricity Association Drawing Office Material Manufacturers' sand Dealers' AssocistionHEVAC Association Gauge and Tools Makers' AssociationInstitution of Chemical EngineersInstitution of Engineering Designers Power Generation Contractors' AssociationUniversity of Warwick
Thas British Standard haingdiretion of the Enginecring been prepared under theSector Board was published under the authority af theStandards Board and es into effect on 15 November 1996
BSI 1996
Amendments issued since publication
Amd. No. Date Text affected
The folowing BS referencesrelate to the work on this standard:Draft announced in BS/ Nees Committee referenceTD4
Contents
Inside front cover PageNational forewordForeword Scope 21 2 Nommative references 3 83 General 34 5 Hellcal pression springs Helical extension springs 3 56 Torsion springs 57 8 Spiral springs 6 69 Leaf springs 7
Nationalforeword
This British Standard has been prepared by Technical Committee TDE/4 and is the English language version of ENISO 2162-1:1996Techicalproduet doeumemtationfor Standardization(CEN）It is identical with ISO2162-1:1993 published by the Springs-Part I:Simplfied representation published by theEuropean CommitteIntemational Organization for Standardization (ISO).
full range of European Standards on technical drawing is implemented BS 308 will be This British Standard partially supersedes BS 308: Part 1. It is envisaged that when thewithdrawn.
Cross-reference
Publieation referred to BSENISO2162Techntcatproduct documentation Corresponding British StandardEN ISO 2162-2 : 1996 BS EN ISO 2162.2: 1996 Presentation of data for cylindrical Springs(ISO 2162-2 : 1993) helical pression springs
Compliance with a British Standard does not of itaelf confer immunity from legal obligations.
EN 2162-1
English version
Technicalproductdocumentation-Springs- Part1:Simplifiedrepresentation
Documentation technique de produits Partie1:Representation simplifiee Ressorts(ISO 2162-1 : 1993)
Teil 1 : Vereinfachte Darstellung Technische Produktdokumentation-Fedem-(ISO 2162-1 : 1993)
This European Standard was approved by CEN on 1906-03.02. CEN members arepnpns euopeu e jo snes a pnpung ueadomg sn Snag no suonuowithout any alteration.
may be obtained on application to the Central Secretariat or to any CEN member. Up-todate lists and bibliographical references concerming suchnational standardsapm uogesnfq peofeaoueuuosan（urg This European Standard exists in three offcial versions (English French responsibility of a CENmember into Its own language and notined to the Central Secretariat has the same status as the official versions.
CENmembers are the nattonal standards bodles ofAustriaBelgum Denmark Netherlands Norway Portugal Spain Sweden Switzerland and United Kingdom.
European Committe forStandardizationEuropaisches Komitee fur Normung Comite Europeen de Normalisation
Central Seeretariat: rue de Stassart 36 B-1050 Brussels
