Technicaldrawings-
Rollingbearings
Part1.Generalsimplifiedrepresentation
The European Standard EN ISO 8826-1: 1995 has the status of aBritish Standard
This Brtsh Suandard hatng been prepared under thedirection of the Rnginarig SetorardwspuedStandards Board and es into15 September 1995 effeet on
BSI1996
The following BSI relerences relate to the work on thisCommitee reference TDE/4 Draft announced tn BST Nens standard:August 1995
ISBN 0 580 23777 X
British Standard Committeesresponsibleforthis
The preparation of this British Standard was entrusted to Technical CommitteTDE/4 Engineering drawing practice upon which the following bodies wererepresented:
Atomic Weapons EstablishmentBritish Gas plcDrawing Offce Material Manufacturers' and Dealers' Asociation British Standards SocietyElectricity Associstion Gauge and Tool Makers' AssoclationHEVAC AssociationInstitution of Chemical Ergineers Institution of Engineering DesignersSociety of British Aerospace Companies Ld Power Generation Contractors' AssociationUniversity of Warwick
Amendments issued since publication
Amd. No. Date Text affected
Contents
PageCommittees responsible National foreword Inside front coverForewordSpecifieation Introduction 31 Scope2 Method of representation3 Hatching
Nationalforeword
This Part of BS ENISO 8826has been prepared by Techncal Committee TDE/4 and is thc Engish lnguage version ofENISO8826-1:1096Teckicl drawingeRollingbearingsPart1:Generl siplifiedrepresentatiompublishedby theEuropean Committee forStandardzationCEN）It is identical withISO8826-1:1989 publishedby the Intemationel Orgarnization for Standardization (ISO).
when the full range of European Standards on technical drawing is implementedBS 308 will be withdrawn.
Cross-reference
Corresponding British StandardBS 306Engineering draering practice Part 1 : 1993 Remendatioms for general principles
Publicastion referred to
ISO 128 : 1982
Compliance with a British Standard does not of itself confer immunity fromlegal obligations.
Descriptors: Drawings technical drawings bearings roling bearing graphic methoris
English version
Technicaldrawings-Rollingbearings Part1:Generalsimplifiedrepresentation
(ISO 8826-1 : 1989)
Dessins techniques-RoulementsPartie 1:Representation sirmplifiee generale(ISO 8826-1 : 1989)
Technische Zechnungen - walzlager Tell 1: Allgemeine vereinfachte Darstelung(ISO 8826-1 : 1989)
bound to ply with the CEN/CENELEC Intemal Regulations which stipulate the This European Standard was approved by CEN on 1005-01-10. CEN members areconditiona for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerming such national standardsmay be obtained on application to the Central Secretariat or to any CENmember.nqSecretariat has the same status as the offcial verslons.
CEN members are the national standards bodles of Austria Belgium Denmark Netherlands Norway Portugal Spain Sweden Switzerland and United Kingdom.
European Committee for Stanxlardization Comite Europeen de NommalisstionEuropaisches Komitee fur Normung
Central Seeretariat: rue de Stassart 36 B-1050 Brussels
