ComPacTTNSX800AC3P/4P
Retain instruction sheet for future use.
PLEASE NOTE
Electrical qpmnt shoud einstalled perated serviced and maintainedNo responsibity is ssumed by Schmeider Eecric for any consequences only by qualified personnel.●All pertinent staste regional. and locsl ssfety regulations must be observed when arising out of non-use of this material.npod su fusn pue Buersu
HAZARD OF ELECTRIC SHOCK EXPLOSION OR ARC FLASH
euipment (PPE) and folw se lctrial work practices See NFPA70E ●This equipment must only be installed and serviced by qualfied electrical personnel. CSA Z462 NOM-029-STPS or localequvalent.uudnb psu o u Bum q udnb su Su/ddns mod je μo n Aways use properyrated volge snsing device to conf pwrisf●Replace all devioes. doors and covers before tuming on power to this equipment. Beware of potential hazards and carefuly inspect the work area for tools andobjects hat may have been left inside the equiment.
Failure to follow these instructions will result in death or serious injury.
请保管好此说明书以供将来使用.
请注意
电击、限炸或弧闪的危险
不遵循上述说明将导致人员伤亡.
电气设备的安装、操作、推修和推护工作仅限于合格人员执行.在安装和使用本产品时，必须遵守国家，地区和当地的相关的安全法规.
采用适当的个人防护设备（PPE）并遵额电气作业安全守则，请参润NFPA70E CSAZ462 NOM-029-STPS 或当地对应的标准只有具备相应资质的电气人员才能安装和维修该没备. 在该没备表面或内部工作之府，请关闭没备的全部电源.确保使用合适的额定电压传感器确认电源已关闭. 复装设备、门和盖，然后再打开该没备的电源.注意潜在危险，仔艇检查作业区，以免将工具和物件遗忘在没备内部.
RequiredforInstallation/必备安装工具
Operation/操作 5
BeforeWorkingonEquipment/设备操作前的准备 6
Clearance Distances/间距
8
Installation/安装
InsulationAccessories/绝缘附件 9
10
TripUnitAdjustment/脱扣单元整定
ManufacturingDate/制造日期
11.1 RequiredforlInstalaion/必备安装工具 11
11.2BeforeWorking onEquipmemt/设备操作前的准备工作 11
11.3Installaion/安装12
11.4 wing/接线13
11.5 wiring Routig/布线 15
11.6ReinstalFront Cover/护盖安装 15
11.7 Accessory Label/附件标签 16
11.9Acessory Removl附件拆除17
RequiredforInstallation/必备安装工具
PKR1559001
C 3P x6 M12 ×303Px4M5 ×45 4P x8 M12 × 304P x6 M5 × 45
4P X3 3Px63P X2 4P x8
T10 T20 wwg
04mm PZ15/32 in. 010 mm PZ23/8 in.
PKR15590074/17
2.1DeviceStatus/设备状态
