ASTM F1667 F1667M-21a 从动紧固件的标准规范钉子、钉子和订书钉.pdf

This international standard was developed in accordance with internationally recognized principles on standardization established in the Deision on Principles for the Development of International Standards, Guides and Remendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation:F1667/F1667M-21a INTERNATIONAL StandardSpecificationfor Driven Fasteners:Nails,Spikes,and Staples This standd isiuddtddsigntF/66M; tndialy follwnhdsintndicas t of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. The Commercial and Goverument Entity (Cage) Code for ASTM: 81346. 1.Scope* 2.Referenced Documents 1.1This specification covers nails spikes, staplesand thr 2.1ASTM Standards:2 driven fasteners, as listed in Table 1. A153/A153M Specification for Zinc Coating (Hot-Dip) on Iron andSteel Hardware Nore 1Fastener ductility information is presented in Table 2 and A641/A641M Specification for Zinc-Coated (Galvanized) dimensional information in Tables 363. Carbon Steel Wire 1.2 Fasteners described in this specification are driven by B695Specification for Coatings of Zinc Mechanically De- hand tool, power tool, or mechanical device in single or posited onIron andSteel multiple strikes and are positioned by hand, tool, or machine. C514Specification for Nails for the Application of Gypsum 1.3 This specification is applicable in either inch-pounds Board C1063Specification for Installation of Lathing andFurring (F1667) or SI units [F1667M]. Values stated in SI are a mathematical conversion to two significant digits and are toReceive Interior and Exterior Portland Cement-Based shown in brackets [ 1. Plaster C1861 Specification for Lathing and Furring Accessories, 1.4 Fasteners in this specification are sold in bulk (loose) and Fasteners, for Interior and Exterior Portla...