ASTM E1190-21 安装在结构构件中的动力驱动紧固件强度的标准试验方法.pdf

This international standard was developed in accordance with internationally recognized principles on standardization established in the Deision on Principles for the Development of International Standards, Guides and Remendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation:E1190-21 INTERNATIONAL StandardTestMethodsfor StrengthofPower-ActuatedFastenersInstalledinStructural Members1 jo o smu uoeulisap u umo pmpou aquu o 0l uou3sp pxy o apun ps s ppus s original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. 1. Scope Building Constructions,Elements, Connections, and As- 1.1These test methods describe procedures for determining semblies the static axial tensile and shear strengths of power-actuated E631Terminology of Building Constructions fasteners installed in structural members made of concrete, E2265TerminologyforAnchorsandFastenersinConcrete concrete masonry, and steel. and Masonry 2.2 ANSI Standard:3 1.2 These test methods are intended for use with fasteners ANSI A10.3 Safety Requirements for Powder-Actuated Fas- that are installed perpendicular to a plane surface of the tening Systems structural member. 3.Terminology 1.3 Tests for bined tension and shear, fatigue, dynamic, and torsional load resistance are not covered. 3.1 Definitions of general terms may be found in Terminol- 1.4 The values stated in SI units are to be regarded as ogy E631. standard. The values given in parentheses after SI units are 3.2Definitions of TermsSpecific to This Standard: provided for information only and are not considered standard. 3.2.1 displacement-movement of a fastener relative to the 1.5 This standard does not purport to address all of the structural member. In tensile tests, displacement is measured safety concerns,if any, associated with its use.It i...